Auto Repair Q&A

Popular

Engine

Cooling System

Brakes

Suspension

Transmission

Exhaust/Emissions

Electrical

Body

Interior

Understand

Directory

Auto Repair Products

kene5116's picture
5

I can't get the oil pan off. I have the engine raised up and the 10 bolts out of the oil pan and the 3 bolts out of the tranny housing to the oil pan. I also have the filter and the housing piece( can't think of the name of it) its attached to...

Donnie Tucker's picture
3

When driving the gagges start fluctuating and engine stalls, have had the cam and crank sensors changed, have replaced the belt and tensioner, have noticed that just seconds before this happens the voltage gage either drops below 10 or jumps...

dewdrop's picture
5

My key is worn and will not turn switch. When manuals state to turn switch to run position to remove. How can I? Or do they mean after removing retaining scrdw , that u turn the WHOLE cylinder to run position. Im saying my key is worn and wont...

longbed's picture
2

My 1983 s10 has a bad vacuum actuator on the fresh air or blend door (it is located in front of the windshield near the wiper motor)where can I purchase this part or get the proper name for it?

LHORNJR's picture
10

I have this 1994 s-10 4.3l 4x4 and have looked high and low for this bracket gm part #15672782 transfer case control cable and I have been unsuccessful in finding one is there anybody out there that can help me possibly locate one?

Matt 909's picture
19

Ok so I have a 2001 chevy s10 2wd automatic, I am getting a slight grinding noise when I accelerate from a stop , if I accelerate very slowly from a stop I don't hear it , it only seems to happen when I give it a bit of gas. I was wondering if...

twistedme's picture
3

WHERE IS THE BATTERY FUSE LOCATED ON MY 1996 CHEVY S-10 2WD EXT. CAB PICKUP?

frankiefly's picture
1

On a 95 Chevy S10 p/u. when bleeding the brake system does truck need to be running? if so, what steps need to be taken? furthest point 1st, workin back towards mast.cylinder ( understood) ive seen conflicting answers? any helps greatly...

mokidog's picture
4

Where is the fuel pump relay located and how do I access

jimmy_hopkins's picture
1

My 1993 4x4 chevrolet s10 wont start out in 1st gear but shifts fine once it starts rolling but feels like you have the brakes on & will not roll backward at all while in drive

Leroyr's picture
3

94 chev s10 4wd is stuck in park. Why?

MattG's picture
2

How do I replace the heater core

DallasFrazier's picture
8

96 s-10 with the 2.2L starting acting up when it starting getting colder outside. replaced the fuel filter, put fuel injection cleaner in it, has the fuel pump tested and was told it works like new, checked the ignition coil, looks new....

regbert93's picture
6

The truck shifts fine but I get a loud vibration when accelerating after I get to about 30 or 35 it stops and sounds like its running fine then when I let off the gas I get a real loud clunking or knocking sound and you can feel it shaking the...

jerrymkronk's picture
2

What is the location of the Starter Solenoid for a 1993 Chevrolet S10 Pickup 6 cyl?

Molly Stark's picture
1

how do you replace the fuel pump module assembly on a 2001 chevy s10 4cyl flex fuel

mannix40's picture
1

i need the diagram of the timing belt of a s10 pick up

mattlittle1's picture
1

i have a 4.3 1998 zr2 s10 the fuel pump went bad and i replaced it since then the truck wont start.. i have checked all the grounds and the fuel pump relay under the hood.. but still nothing i can run a hot wire to the pump and it fires right up...

luke1's picture
1

will run off back tank if you u bypass the selector but if not it will run 3to 4 mi then die and i can not get it to take gas like it sould in the back tank

unsafenut's picture
7

I have a 2001 chevy s10 and when i run my a/c it starts up just fine for the first few seconds. Then a low rumbling starts and then that turns into a somewhat of a loud grinding noise. The whole time my a/c keeps blowing cold air but the fan...